Use and instructions of wood crusher：Use method of wood pulverizer (wood pulverizer wood pulverizer)

Use and instructions of wood crusher：Use method of wood pulverizer (wood pulverizer wood pulverizer)

1. Turn on the power to see if the steering is correct;

2. When installing and replacing the tool, the knife edge extends 2-6mm beyond the cutter head plane, and then tighten the bolt. If the screw thread of the pressure bolt is found to be worn, it should be replaced immediately to prevent the nut of the sliding cutter head from being damaged;

3. Change the extension of the knife. 1. The extension length of the knife must be the same;

4. When the machine is used, it does not change the power and speed, sharpens the knife angle, and maintains the original straight line of 28-30 degrees. It is strictly prohibited to grind the convex surface, which will cause the steel edge to detach or partially uncover the steel;

5. Depending on the length of the cutter, when the particle size is less than 1, change the sieve with different apertures; (To change particles, it is necessary to change the roller and adjust the cutter at the same time. The small diameter of the roller hole is not less than 3mm (diameter), the large diameter is not more than 20mm (diameter), the length of the cutter is between 2-6mm, and the gap between the bottom cutter plate and the cutter is not more than 1mm)

6. It is strictly forbidden to put wood with stones and nails into the machine to prevent damaging the knives and internals;

7. Pay attention to check the hammer bolts. If they are loose, tighten them immediately. If the hammer and bolts are seriously worn, replace them;

8. Frequently used machines should be checked for lack of bearing grease. Add butter once every 3-4 hours, and it is not easy to add too much butter;

Precautions for wood pulverizer (wood pulverizer wood pulverizer)