Scrap aluminum crusher

Scrap aluminum crusher, scrap aluminum crusher production line is used to process scrap car bodies, tinplate, old home appliances, bicycles, refrigerators, color steel tiles, empty cans and other inferior scrap materials to make them into superior steel materials. The scrap steel crusher is used to continuously pulverize, remove the coating film, increase the volume proportion, prevent failures when putting into the electric furnace, and increase the dissolution rate under a certain state, so as to meet the steel mill's "fine material into the furnace" requirements. Our company’s scrap crusher has low noise, no pollution, high crushing efficiency, finely crushed material, uniform particles, and the price of scrap crusher is very cheap. According to different models, the price of scrap crusher is different in the market, but our company's scrap crusher The price is absolutely fair, and friends from all over the country are welcome to visit our factory for on-site inspections. Our scrap steel crusher production line will never disappoint you.

The aluminum scrap crusher uses the kinetic energy generated by the high-speed rotation of the hammer to crush the scrap steel. During the crushing, the rust, paint and other surface dirt on the surface of the scrap steel can be stripped, and then under the action of the magnetic separation equipment, a certain size specification can be obtained Of pure broken steel. It has a particularly obvious effect on the treatment of unsorted and mixed low-quality steel scrap and scrapped cars, and it is the current tool for improving the quality of scrap steel.

The scrap aluminum crusher can process the following scrap steel: flat or unflattened whole cars with or without engine; light and thin materials with a density of less than 1t/m3 after shearing or packing; plate thickness less than 6mm, width less than 2.6 meters, length not more than 5 meters scrap steel; household appliances such as air conditioners, washing machines, refrigerators, etc. It uses hammering to crush scrap steel. In the crushing process, surface dirt such as rust and paint on the surface of the scrap steel can be separated, and then under the action of a magnetic separation device, the non-ferrous metals, plastics and rubber mixed in the scrap steel can be separated. Metal waste is piled up separately. Not only can we obtain pure crushed steel, but also non-ferrous metals recovered by manual selection. The bulk density of pure crushed steel can reach about 1.2t/m3, which is an ideal charge for electric furnace steelmaking.

Due to the limitations of the strength and power of the crusher, the crushing capacity also has certain specifications depending on the model. The unbreakable materials of the scrap steel crushing production line are: steel cables 22 mm thick and more than 7.5 meters in length; alloy steel shafts with a diameter of more than 25 mm; mild steel shafts with a diameter of more than 37 mm; thicknesses of more than 20 mm and side lengths of more than 300 Plates with a thickness of more than 25 mm and a side length of more than 150 mm; structural profiles with a cross-section of more than 12.5 mm; steel bars with a diameter of more than 40 mm; high-carbon steel round steel with a diameter of more than 12 mm; steel ingots, billets and similar Materials, etc. For non-crushable materials, a discharge door is installed on the upper part of the crusher to protect the machine. The discharge door can be quickly opened to make the non-crushable materials eject from the crusher to reduce the damage to the machine.